35718 Product Support PRD: Trailing edge backbone is down, cannot move or spin the drum Japanese_Newspaper_OEM_Engine Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The trailing edge backbone, which contains the trailing edge clamps, is down. Any movement to the drum could damage the machine. You must raise the clamps before you can move or spin the drum. If this happens during normal operation of the machine, then there is likely a problem with a sensor or the air supply. Check to make sure the sensor is not malfunctioning. Check air supply to the machine, make sure the balancing locks are not being blocked and not able to raise. This error is reported. Trailing edge clamp is down while attempting to move or spin drum. Bad air supply. Bad sensor. Blocked balancing locks. 10-JUN-2003 Improved readability. ../commands/tec_-on_or_off-.xmlCommand: tec <on|off> ../commands/tec.xmlCommand: tec ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:05 2008 PST